![]() ![]() ![]() Now these chips are under the bpf board and I just did't want to chance removing it again. When I first read this mod I thought it said jump R802 and R803 to 0 ohms so I swapped in 0 ohm smd's and put it all back together and the low band was still dead. THE PROBLEM: I am the owner of an Icom 756 Pro II and the PW-1 KW. I fucked up and was supposed to bridge 802 and 803 and after going over it all again, tore back into it again today. If you have a PW-1 you most like think it is a good amplifier but a lousy client on the CI-V bus, the single wire serial communication bus that runs between ICOM equipment. The problem with the CI-V bus are many making for a very fragile system. I put in 2 new 100ohm's and Replace C802 that the mod said to remove also. Maybe Yvo and TRX and Mike have all the fancy equipment to make this easier but I dont so some stuff is crooked and difficult to get to. ![]() Some plastic got nicked but in the end a miracle happened and the radio works top notch now.ĭont try this without flux. The flux is the secret to not vaporizing parts. I basically hold the part down with a small screwdriver and tack them down with the iron and lots of flux. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |